What would cause this? - Bambu Lab X1-Carbon - Bambu Lab Community Forum

Por um escritor misterioso
Last updated 22 março 2025
What would cause this? - Bambu Lab X1-Carbon - Bambu Lab Community Forum
The original hot end ended up getting bent (don’t know how, but it did). I replaced it with the included replacement. I did a calibration and everything looked fine. I went to print a simple model on extra fine 0.08mm on the BBL textured PEI plate (as see in the pic) with Overture PETG. As you can see, the nozzle tip gouged the plate and broke off and ended up bending the hot end. What would have caused this to happen? Did I miss a step in the installation of the replacement hot end? Is t
What would cause this? - Bambu Lab X1-Carbon - Bambu Lab Community Forum
Bambu labs x1-Carbon
What would cause this? - Bambu Lab X1-Carbon - Bambu Lab Community Forum
Bambu Lab Official User Group
What would cause this? - Bambu Lab X1-Carbon - Bambu Lab Community Forum
A Variety of Observations and Complaints - Bambu Lab X1 Series
What would cause this? - Bambu Lab X1-Carbon - Bambu Lab Community Forum
Bambu Lab X1 Carbon: Info & Discussion (SRO) - Esk8 Electronics
What would cause this? - Bambu Lab X1-Carbon - Bambu Lab Community Forum
Bambu Lab X1 Carbon Combo Review - The Tesla of 3D printers
What would cause this? - Bambu Lab X1-Carbon - Bambu Lab Community Forum
Bambu Lab X1-Carbon Review: Living In The Future : r/BambuLab
What would cause this? - Bambu Lab X1-Carbon - Bambu Lab Community Forum
Bambu Lab P1S Review: A New Standard for 3D Printing
What would cause this? - Bambu Lab X1-Carbon - Bambu Lab Community Forum
Bambu Lab X1 Carbon Combo Review - The Tesla of 3D printers
What would cause this? - Bambu Lab X1-Carbon - Bambu Lab Community Forum
Bambu Lab X1C vs. P1S: Clash of the Titans in the 3D Printing

© 2014-2025 renovateindia.wappzo.com. All rights reserved.